|
Chogyam Trungpa Gyatso,
Tibetan Monk
|
When you stamp metal it changes these flow patterns and thus stops the heat from properly radiating out to the edges.
|
|
Miles Rhodes,
Wine Taster
|
Are the shingle tab edges supported by a cedar shingle starter course or metal drip edge flashing?
Metal edges are advised for dining or coffee tables, and all outdoor tables.
The metal edges allowed use at regular ski resorts and the rest is hiss-toe-ree.
|
|
Rob Bruff,
Nightclub Bouncer
|
FERRULE The metal part which closes onto the tang at the blade end of the wood handle HOLLOW GROUND Blades are ground across the section so that only the cutting edges are touching at the point of cut thus reducing drag.
|
|
Sarah Kennedy,
Fashion Model
|
Drafting board style metal stops at top and bottom edges keep paper or pad from sliding off when table is tilted.
The edges have reinforcement as well with metal braid soldered to the glass and/or brass rims for support depending on the style and how it will be shown and used.
Metal finishing work is done with the greatest of care to insure all screw holes, edges, contours, and markings are protected.
|
|
Billie Kirgan,
Machinist
|
In strip metal welding the plasma process is consistent in transferring the arc to the workpiece and working up to the edges of the weld joint.
The metal hinders airflow and can also cause whining/vibrations because of air passing over the edges of the metal.
|
|
Chrissie Tanner,
Homemaker and Mom
|
Metal edges don't help you turn the skis, but they do bite into harder snow on a downhill, lending the skier more stability.
|
|
Sasha Prevette,
Kindergarten student
|
The board edges should be high grade metal and always buy a board with high grade p-Tex base.
|
|
|
