From:
usarocks_1@yahoo.com 2005-04-13 10:57:51
|
can u send me a someting on lawn mower carbartor kits and how to replace them |
From:
lopesky@hotmail.com 2005-04-27 22:31:26
|
can lawn mower engines be modified to run counter clockwise? If so, can you tell me how? |
From:
Tony 2005-04-29 23:48:54
|
where is the points on a 14 hp briggs and straton engine? Under the flywheel? |
From:
matt 2005-05-22 13:51:27
|
I have a murray push lawn mower model number 20495x92d. It is a "throttle free" model. When I mow, the engine will hunt rather than run at a consistant speed. I think the governor is sticking or needs to be adjusted. How do I do this. |
From:
mattyohughes@hotmail.com 2005-05-22 13:54:18
|
I have a murray push lawn mower, model 20495x92d. It is a "throttle free" model. When I mow, the engine hunts rather than operate at a consistant speed. I think that the governor is sticking or needs adjusting. How do I do this? |
From:
rodger101us@yahoo.com 2005-06-25 04:43:20
|
i have this lawnmower engine its an 18 v-twin model 422707 type 1507 code 88092712 its getting gas to the carb but gas isnt pumping into it what can i do? |
From:
Rodney Bowers 2005-07-21 13:07:35
|
I have a Gravely mower, (SN00563171)which had a kohler engine in it,but,
has hadtoo many problems. Am told it would cost a bundle to rebuild, so .would like to put new engine in. Was wondering if a different engine would line up,and, bolt in? And, what engine that might be? Any help would be appreciated. |
From:
obets333@aol.com 2005-08-01 14:28:11
|
I've got a toro push mower. It just stopped running one day. It does not have fire. I had the coil checked and was told it was good. Replaced plug again, to be sure. I do not know what to do. |
From:
hiwaystar2003@yahoo.com 2005-08-07 12:53:15
|
how do you make and engine counter clockwise? |
From:
Michelle 2008-04-08 19:02:42
|
How hard is it to change the points in a murray push mower? Where are they located? |
From:
Sid 2007-10-22 19:50:07
|
My riding lawn mower is mixing fuel and oil and blowing it back through the carb and exhaust. What is causing this? |
From:
jhj 2009-02-15 12:45:06
|
goveners |