From:
dan
2004-11-24 16:55:40
|
do you have any information on a honda lawn tractor made by john deere for honda in 1999 model ha4120h48a? |
From:
kenny
2005-03-08 06:01:56
|
Where is the oil drain plug on a honda harmony mower. This mower has that plastic deck. It is an HRB217HXA. Thanks |
From:
randy / rpscripps@sbcglobal.net
2005-03-22 15:46:29
|
need a carb for my hr214 sx
ser# 6102838
were the best place to order it ???? |
From:
G
2005-05-01 00:24:07
|
Do you know how to reconect the clutch line that makes the lawn mower go by it's self on a Honda Harmony? |
From:
dave
2005-05-18 09:54:18
|
where can I get a blade clutch cable for my honda hr214? |
From:
brandon
2005-06-22 15:21:18
|
i have a honda hr215 about '93 model i have a couple questions....HELP
|
From:
sc
2005-08-07 19:03:11
|
My son tipped my mower over to clear grass from the mower and now there is white smoke when I start the mower. Will this cause any harm?? |
From:
Chris
2005-09-02 05:33:58
|
Ihave a Honda Harmony 215 Hydrostatic mower. The self propeling left wheel is very loose and I cant seem to tighten it up. |
From:
herkysmom
2008-07-13 20:12:35
|
I replaced the bolt in my crank shaft on my honda harmony 215 and now the blades turn freely but don't seem to be cutting. like they are not engaging any suggestions |
From:
Jackie Frazier Sr
2008-03-10 20:09:04
|
A friend of mine has a honda HRX 217 VKA that wont start. Checked spark plug, it was wet with gas. Clean and dried plug, still wont start. Can use some help!! |
From:
jeremy
2008-07-22 18:20:34
|
Where is the drain plug on my honda harmony II HRS 216 mower |
From:
mary
2008-08-02 19:42:03
|
We lost the bolts that hold the handle in an upright position (They werre down by the engine where there is three adjustment holes.). Do you know the replacement size or do I need special bolts from Honda? |
From:
Rasik
2009-06-23 06:28:51
|
I have a Honda HRR216 self propelled lawn mower. I am trying to replace the rear wheel adjuster which broke. I have removed all the parts except the adjuster plate which will not come out of the rod. Is this press fitted to the rod? The adjuster is right behind the plate. |
From:
mike
2009-03-28 12:29:33
|
honda hr214 lawnmower. carb float needs adjusting, gas is leaking pretty bad at the bowl gasket, can someone
please tell me the proper way to adjust the floatlevel? honda makes the best!!! |
From:
Hal
2009-05-21 10:04:33
|
I need to replace the rear wheels on my HR214 mover. How do you remove the wheels. Is the hex cap threaded or just a cap? |
From:
Ryan
2009-05-23 10:43:07
|
What kind of plastic is the deck made out of on my Honda Harmony 215 lawn mower? It has cracked nearly all the way around the front left wheel and would like to use an epoxy to fix. However, if it is polypropylene or polyethylene none of the epoxies will work. |
From:
colin
2009-05-25 17:56:50
|
what are the options for the mower blade clutch adjustment in honda push mowers?
|
From:
ante sioson
2009-07-20 19:00:14
|
I need to replace the rear wheel of my honda (HRM215), how do I do it? |
From:
Wes
2009-08-09 11:49:48
|
I need to replace the rear wheels on my HR214 mover. How do you remove the wheels? |
From:
jj
2009-09-22 20:31:33
|
honda hrm215, manual says to drain by tipping over? There is a drain bolt down toward the bottom of the dip stick area. is this to drain the motor oil? also it stalls when i engage the blade. How do i correct this?
thanks |
From:
Mark
2009-11-04 10:11:48
|
I have a Honda Harmony mower. It starts hard. I have to pull the rope about 50 times before it will start. Once started it will start again in 1 pull. Suggestions? |
